Ratoc Systems CBFW3 Manuál s instrukcemi stáhnout pdf (Strana 17)

Names and Parts

1-9

9 Output connector (When the analog playback amp card is installed in the slot.)

Outputs the reproduced signal. Outputs the input signal during recording-standby status or during recording.

You can set the output range in 0.1 V steps, from 1 V to 5 V.

10 Output level LED (When the analog playback amp card is installed in the slot.)

When the output signal for a channel is larger than +/-10% of a set output range, the LED glows green.

When the signal exceeds +/-115% of the range, the LED glows red.

11 P LOCK button

Pressing this button for 3 seconds causes the lamp to glow and disables the five buttons on the left: STOP,

REC, FWD, PAUSE, and EVENT. To release the lock, again press the button for 3 seconds.

12 Recording/reproduction control buttons

Buttons used for recording or reproduction. Details are given later.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 145 146

Žádné komentáře

Ratoc Systems CBFW3 Manuál s instrukcemi Strana 17